Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
We calculate air mover and dehumidifier placement using psychrometric formulas, not a flat per-room equipment count.
A calculated drying plan means faster results with the right amount of equipment, not excess.
Our Jemez Pueblo, NM jobs run commercial LGR equipment sized to the calculated moisture load.
We map hidden moisture with thermal imaging before finalizing equipment placement.
Daily logs give you and your insurer verifiable proof of progress, not a technician's word.
Here's the full scope of a Structural Drying And Dehumidification job in Jemez Pueblo, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
Thermal cameras scan walls, ceilings, and flooring to reveal moisture invisible to the naked eye.
Dehumidifier capacity is matched to the calculated moisture load for that specific space.
A technician returns daily to take moisture readings and log progress against the drying plan.
We adjust drying speed for sensitive materials like hardwood and cabinetry to prevent secondary damage.
The job closes only once moisture readings match the documented dry standard for each material type.
A quick call helps us determine whether thermal imaging and full drying equipment are needed.
A technician arrives with thermal imaging cameras and moisture meters ready to assess.
We complete the psychrometric assessment and thermal scan, then provide a written drying plan and quote.
The job closes only once documented readings confirm the structure is fully dry.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
We rely on moisture meters and thermal imaging, not appearance alone.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
We provide daily documented logs showing moisture readings, not just a verbal update.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We treat flat readings as a signal to recalculate, not something to wait out.
Jemez Pueblo is within our core structural drying response zone.
One call starts the psychrometric assessment process.
Call +1-844-833-1325